These photos don't show the newest very nice updated electrode handler.

Pic 1 shows typical setup. [Batteries not included]............................................... Pic 2 shows a variety of different ways to power the Generator...............Pic #3 shows how the electrodes mount.

This is a small portable device that will run on a variety of power sources.

It uses the same circuitry as my more expensive full featured Colloidal Silver Generator, but in a smaller easier to build package and with fewer "Bells and Whistles"

It can also be used for experimental "Blood Electrification" and "Iontophorosis" ..check with your "group" for acceptable parameters and email for modifications if needed. odecoyote2@windstream.net

Apparently the premier "Zapper" group:

http://health.groups.yahoo.com/group/microelectricitygermkiller/

How they work and what they actually do

Features:

"S.W.A.P." [Square Wave Alternating Polarity] output only. [No DC out selection]

No "Manual Mode"

Automatic off @ a number of "PPM" settings determined by in which holes you place the electrodes. [up to 10 or 20 uS and up to 30 with a wider jar]

["Plug n' Play" in a pint batch yields 5, 15 or 25 PPM at Auto Off.]

Note that "PPM" and uS [Microsiemens of conductivity as meters read things] can be, but are not "quite" the same thing..as explained in the instructions.

Input polarity sorted out internally..[You can't hook it up wrong.]

Powered by virtually ANY source between 10 and 36 volts AC or DC........it all comes out the same. [You may have a wall transformer in your junk drawer that will do]

Standard Package: [Batteries not included]

"PocketPuppy" Kit Contains:

1] Colloidal Silver Generator with output leads.

1] Power input adapter for batteries, solar panels etc. [aka Battery Adapter]

1] OEM wall power supply

1] Set of two 12 gauge .9999 fine silver electrodes.

1] Multi position electrode handler. [The nice new round one] It's very important to do precision placement and this makes it easy.

1] Set of instructions.

Here's the "Generator" opened up so you can see all the tiny little energy efficient integrated circuit chips, capacitors and stuff in there....ALL "Solid State" Tech ...REAL Engineered GUTS!! Only pulls 7 milliamps. big view

You supply the container and distilled water...the electrode handler serves as a jar adapter, so nearly any container will do.

Optional:

Function additions at extra charge:

Add "DC Output Mode" $5

Add "Manual Mode" $5 [Recommended for survival situations when "good" water isn't available. ]

UK Adapter Plug needed for OEM wall power supply in the UK [$5]

Thermal Convection Stirrer [aka Heater Lamp] or Magnetically Coupled Stirrer [mag stirrer]

No stirrer included [The SWAP function itself does some stirring and is sufficient in smaller batches up to a pint...does decently in a quart too. ]